40English <>Replacing the dust shield packFollow these steps:Replacing the 3D dust filter1 Turn the projector off. Wait for the Power LED to stop flashing thenunplug the power cord.2 Allow the projector at least 30 mins to cool down.3 Use a screwdriver to remove the screw from the 3D dust filter. (Illustration#1)4 Remove the 3D dust filter. (Illustration #2)Replacing the Lens shield1 Open the top cover from the lens shield. (Illustration #3)2 Use a screwdriver to remove the screws from the lens shield. (Illustration#4)3 Remove the lens shield. (Illustration #5)To install the 3D dust filter and lens shield, please reverse previous steps.To reset 3D dust filter after installing.Note: Considering the performance of 3D dust filter, it is notrecommended to clean the electrostatic filters. Please contact yourlocal dealer or serviced center to purchase and replace newelectrostatic filters inside 3D dust filter.124533D dust filterLens shield
