32 Chapter 2AdvancedThe Advanced screen allows the user to configure the various advanced BIOS options.IMPORTANT:Making incorrect settings to items on these pages may cause the system to malfunction. Unlessyou have experience adjusting these items, we recommend that you leave these settings at thedefault values. If making settings to items on these pages causes your system to malfunction orprevents the system from booting, open BIOS and choose Load Optimal Defaults in the Exit menu toboot up normally.The table below describes the items, menus, and submenus in this screen. Settings in boldface are the defaultand suggested parameter settings.Parameter Description Submenu ItemsSerial port Determines serial port behavior, Disabled,Enabled, or Auto configure.N/AParallel Port Determines parallel port behavior, Disabled,Enabled, or Auto configure.N/AInfrared Port(FIR)Determines FIR port behavior, Disabled orEnabled.N/ABase I/O address Select the base I/O address for serial port A. N/APS/2 Mouse Determines PS/2 mouse port (IRQ12)behavior, Disabled, Enabled, or Auto Detect.N/AInstalled O/S Select the most commonly used O/S on thesystem from Win95, Win98, WinMe,Win2000, Win XP, or Other.N/AResetConfigured DataClear the Extended System ConfigurationData (ESCD) area. Select No or Yes.N/ALarge DiskAccess ModeFor UNIX, Novell Netware, or other OSselect Other. If installing new software andthe drive fails, change this option and tryagain. Default setting is DOS.N/AInformation Main Advanced Intel Security Boot ExitItem Specific HelpSerial port: [Auto][Disabled]Parallel Port: [Auto] Serial port is notactive.Infrared Port (FIR): [Enabled] [Enabled]Base I/O address: [680/IRQ3/DMA1] Serial port is activeand is user configured.[Auto]PS/2 Mouse [Auto Detect] Serial port is activeInstalled O/S: [Win XP] and is automaticallyReset Configuration Data: [No] configured.Large Disk Access Mode: [DOS]IDE Controller: [Disabled]X Keyboard FeaturesX Cache MemoryF1 Help ↑↓ Select Item F5/F6 Change Values F9 Setup DefaultsESC Exit ←→ Select Menu Enter SelectXSub-Menu F10 Save and ExitPhoenix SecureCore(tm) Setup Utility
