Jumper and Connector Locations 5-5Clearing Password Check and BIOS Recovery 0This section provides procedures for:Clearing the BIOS passwordsPerforming a BIOS recoveryClearing the BIOS Passwords 0To clear a lost BIOS password (user or supervisor password), you need to short the clearpassword hardware gap (G2201) located on the mainboard.Figure 2-3. G2201 Hardware Gap1. Shut down the computer and disconnect the AC adapter and all other peripherals from thecomputer.2. Remove the battery pack and base door.3. If the Mini Card slot is occupied, remove the installed wireless module.4. Locate the G2201 gap.5. Use an electrical conductivity tool to short the two contacts on the hardware gap together.6. While resting the tool on the two contacts, plug one end of the AC adapter into the DC-injack and plug one end to an electrical outlet.7. Press the button to turn on the computer.8. After the BIOS POST, remove the tool from the hardware gap.9. If a wireless module was removed, reinstall it.10. Reinstall the battery pack and the base door.11. Turn on the computer and press F2 during bootup to access the Setup Utility. If nopassword prompt appears, the BIOS passwords have been cleared. If the promptappears, repeat steps 4-9 until the BIOS passwords have been cleared.12. Press F9 to load the system defaults.13. Press F10 to save the changes you made and close the Setup Utility.HTTP://MYCOMP.SU/ - Maintenance and Service Guide,Service Manual,Motherboard Schematics for Laptop/notebookРЕМОНТ НОУТБУКОВ. Запчасти и комплектующие для ноутбука. Схемы, сервис мануалы, инструкции по разборке ноутбука.ВОССТАНОВЛЕНИЕ ДАННЫХ. г. Санкт-Петербург, Тел.(812)951-37-99, Тел.8-921-951-37-99,ICQ:573812745, service@it-lux.ru
