Acer Veriton A430_31 User Manual

Acer Veriton A430_31 User Manual Manual pdf 33 page image

23Englishb The equipment shall go on-hook for a period of not less than 30seconds between the end of one attempt and the beginning ofthe next call attempt.4 Some parameters required for compliance with Telecom's Telepermitrequirements are dependent on the equipment (PC) associated with thisdevice. In order to operate within the limits for compliance with Telecom'sspecifications, the associated equipment shall be set to ensure that automaticcalls to different numbers are spaced such that there is not less than5 seconds between the end of one call attempt and the beginning of another.5 This equipment shall not be set up to make automatic calls to Telecom's 111Emergency Service.6 This device is equipped with pulse dialing while the Telecom standard is DTMFtone dialing. There is no guarantee that Telecom lines will always continue tosupport pulse dialing.7 Use of pulse dialing, when this equipment is connected to the same line asother equipment, may give rise to bell tinkle or noise and may also cause afalse answer condition. Should such problems occur, the user should NOTcontact the telecom Fault Service.8 This equipment may not provide for the effective hand-over of a call to anotherdevice connected to the same line.9 Under power failure conditions this appliance may not operate. Please ensurethat a separate telephone, not dependent on local power, is available foremergency use.Laser compliance statementThe CD or DVD drive used with this computer is a laser product.The CD or DVD drive's classification label (shown below) is located on the drive.CLASS 1 LASER PRODUCTCAUTION: INVISIBLE LASER RADIATION WHEN OPEN. AVOID EXPOSURETO BEAM.Digital audio output statementThe optical connector contains no laser or light emitting diode (LED) more thanClass I.Radio device regulatory noticeNote: Below regulatory information is for models with wireless LANand/or Bluetooth only.