Acme Packet Net-Net 2620 Installation Manual
Also see for Net-Net 2620: Quick installation
Contents |
Installation referencesSystem Installation and Commissioning GuideNet-Net® 2620 Network Interface Card (NIC) InstallationWhat’s inside the box?• Network interface card (P/N HW-NIC-2TX,HW-NIC-2TE, or HW-NIC-2SX)Tools required:• Phillips #1 and #2 screwdriver.• Attach an antistatic wrist strap when handlingall components in this installation.3 Remove the riser assembly.1. Disconnect any cables attached to any of theinstalled network cards.2. Lift up on the two levers on the riser to liftthe assembly from the chassis.4ClipClipNetwork interface cardInstall the NIC card(s) into the riser assembly.1. Open the blue retention clips, both of them, as shown.2 Insert the card, pressing it in until it seatsin the riser full-height card connector slot number 2. Make surethe bracket inserts into the matching slot.3. Look at the Ethernet connectors on the interface side to ensurethat the card is properly oriented, and not crooked.4. Close the blue retention clips.5. Repeat this step to install additional NICs in riser slots 4, 3,5 and 6, in this order. Slot 1 is not present in the Net-Net 2620.Note: The 2TX and 2SX cards fit in the full-height slots only.246Connect cables and re-install the riser assembly.1. Set the riser assembly straight down, matching thehooks in the back of the riser assembly to the notchesat the rear of the chassis.2. Press firmly to push the insert into the slot on theserver board.3. Connect the cables to the NIC.52 Remove the air duct.1. Lift the processor air duct from its locationover the processor sockets.2. Put the air duct aside for reinstallation later.®Remove the Net-Net 2620 top cover.1. Unplug the chassis and remove itfrom the rack.2. Disconnect the power cord.3. Remove the shipping screw (A)4. Holding the blue button (B), slide thetop cover back.5. Lift the top cover upward and remove it.A finger notch is provided for lifting.1Use these instructions for installing standard networkinterface cards in Net-Net 2620 systems without thepresence of any media expansion cards. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine