Page 23. Installation and PositioningDiagram TwoAn adjustable wall bracket is supplied with each Aego-T satellite. To install thewall brackets proceed as described below and illustrated in Diagram Two.Note: It is very important that wall brackets are fitted securely. If youare in any doubt about your ability to achieve a secure installation youshould seek professional advice and assistance.The wall bracket is held to the wall via two screws inserted through elongatedholes in the bracket’s wall plate. No.8 (4.5mm) round-head, rather thancountersunk-head, screws should be used. The length of screw necessary andtype of wall fitting required will depend on the construction and conditionof the wall. If in any doubt seek professional advice.Once the wall mounting locations for Aego-T satellites have been chosen usethe wall brackets themselves as templates to mark the screw positions. Loosenthe bracket adjustment screw using the allen key supplied and angle themounting post away from the wall plate to gain easier access to the holes.With the screw holes drilled and appropriate wall fittings inserted, securelyscrew the brackets to the wall and return the mounting post to the vertical.LeftFrontViewing/listening positionRightFrontCentreLeftSurroundRightSurroundAlternativeor Extra LeftSurroundAlternative orExtra RightSurroundSubwooferWall PlateMounting PostBracket AdjustmentScrewAego-T Wall BracketAego-T Satellite and WallBracketDiagram One4. Wall BracketsNote: The elongated bracket holes enable someadjustment for vertical alignment.To attach an Aego-T satellite to a wall bracketsimply place the satellite above the bracket andslide it onto the mounting post.Note: Connecting cables to Aego-T satellites is bestdone before they are mounted on wall brackets. SeeSection 5.Loosen the bracket adjustment screw to adjust thesatellites vertical angle. Turn the satellite on themounting post to adjust its lateral orientation.AE12 Rev I 8/9/05, 2:35 pm2