Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Acromet WG-602 Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Page 39 preview
Page 40 preview
Page 41 preview
Page 42 preview
Page 43 preview
Page 44 preview
Page 45 preview
Page 46 preview
Page 47 preview
Page 48 preview
Contents
  1. Preface
  2. Table Of Contents
  3. Table Of Contents
  4. Overview of Chapters
  5. Wireless Management Package
  6. Installation
  7. Plumbing Requirements and Installation
  8. Drainage
  9. First Time Operation and Calibration
  10. Menus
  11. Configuring Settings in the Operator Menu
  12. Calibrating other Sensors and Meters
  13. Configuring Settings in the Technician Menu
  14. Monitoring WaterGuard Alarms
  15. Troubleshooting
  16. Replacing Flow Switch
  17. Module Software Update
  18. Software Set-up
  19. Routine Maintenance
  20. Shut-down and Winterizing
  22. Relay Wiring and Use
  23. First Time Set-up and General Operation
  25. Replacing Components
  28. Routine Maintenance and Troubleshooting
  29. Internal 4 to 20mA Output
  30. Appendix A: Relays and Closed-Loop Control
  31. Proportional Control Overview
  32. Setting Proportional Factor
  33. conductivity calibration
Acromet WG-602 Manual Manual pdf 19 page image
194.3 TroubleshootingThe following procedures instruct how to locate, evaluate, and fix a problem when WaterGuard issues analarm or indicates suspect chemical levels.4.4 Replacing ComponentsThe following procedures describe how to replace certain WaterGuard components.Caution: The following procedures should only be performed by properly qualified and trainedWaterGuard analyzer technicians.Warning: Disconnect all power supplies to the WaterGuard analyzer before opening the control unit door.Replacing any parts of WaterGuard without the expressed written authorization of Chemical InjectionTechnologies, Inc., or the qualified representative who supplied the product may void the warranty.Chemical Injection Technologies, Inc., takes no responsibility, written or implied, for installation ormaintenance of WaterGuard that is not performed by a properly trained and certified WaterGuardtechnician.
/ 48
This manual is suitable for:
WG-602
Manuals database logo
manualsdatabase
Your AI-powered manual search engine