Acteon Satelec Mini LED 2 ORTHO User Manual

Contents

Acteon Satelec Mini LED 2 ORTHO User Manual Manual pdf 7 page image

User’s Manual Mini LED ORTHO 2 ● J05221 ● V1 ● (13) ● 09/2013 ● N005EN010A ● 7when the handpiece is in standby mode.Charging baseThe charging base is used to recharge the battery andalso includes a translucent handpiece holder (Fig. 1-9)and a power level verification window (Fig. 2-10). Thetranslucent handpiece holder holds the unit in thecharging base and also lights up to indicate chargingstatus. The power level verification window is locatedon the front of the charging base and serves to verifythe power output of the light curing unit.Place the charging base on a hard, level, stable surfacewith an inclination of no more than 5°.When the charging base’s AC power is plugged in, thetranslucent handpiece holder beeps and flashes red,green, and blue.Place the curing light on the holder ensuring that thereis good contact between the spring loaded contactson the charging base and the copper contacts on thebottom of the battery. Two beeps confirm that the unitis correctly positioned on the charging base and thetranslucent holder flashes blue, indicating that thebattery is charging.When the battery is completely charged, thetranslucent holder will shine steady blue.Power level verification windowThe procedure for using the power level verificationwindow is as follows: Check that the power levelverification window is intact and clean.Ensure that the light guide is intact and clean andinsert it into the handpiece.Place the tip of the light guide flat against the powerlevel verification window and activate the curing light.The translucent handpiece holder will shine green ifcompliant power level is detected or red if the poweris insufficient.If the power level is low, please refer to chapter IVTROUBLESHOOTING in the general user’s manual forSATELEC curing lamps.Technical specificationsModel name: Mini LED™ ORTHO 2Dimensions without light guide:Weight: 160 gDimensions: Ø24 x 201 mmOperation: Continuous operationProtection:Category: Type BProtection: 5 A T fuse F1 (non accessible) 125 VProtection index: IPX0AC power adapter:Input voltage: 100 V AC to 240 V ACFrequency: 50 Hz to 60 HzOutput voltage: 12 V DCOutput current: 0.8 ACategory: IIProtection index: IP 41Reference: FRIWO FW7660M/12Charging base:Input voltage: 12 V DCProtection: 3 A T fuse (non accessible) 125 VCategory: Continuous operationProtection index: IPX0Battery:Type: Lithium-IonDimensions: Ø24 x 88 mmCapacity: 2400 mAhOptical specifications:- LED for polymerization:Wavelength range: 420 - 480 nmPeak wavelength: 455 – 465 nmIntensity: 3000 mW/cm² ± 10% foropalescent light guide diameter of 5.5 mmClass: IIa according to Europeandirective 93/42/EECMaximum exposure time:32 secondsTemperatures:Operation: +10°C to +40°CStorage: 0°C to +50°CHumidity:Operation: 30% to 75%