Getting StartedThe ActiVHeat® Lithium Polymer Battery Pack is supplied withan ON/OFF hibernation slide switch and you should slide thisswitch using a pen or small tool to ON now to activate it.Because it is supplied with a low maintenance charge, youshould charge it fully upon receipt. The first time full chargemay take up to 6 hours. Thereafter it will take approximately 3hours. This Battery Pack does not require pre-conditioning andwill deliver 100% of power from the first cycle. Always keep theBattery Pack and Charger out of reach of children.Charging the Battery PackThere are two sockets & aswitch on the BatteryPack. The smaller socket(A) connects to theCharger and the largersocket (B) connects to thegarment plug.The switch (D) is a hiber-nation storage switch andmust be slid using a pen or small tool to the ON position tocharge or operate. You should only slide the switch to OFFwhen you don’t plan to use the battery pack for more than 2months.1. Plug the wall charger into an active electrical outlet.2. Ensure the battery pack switch is slid to the ON position.3. Insert the charger plug into the smaller socket on the BatteryPack.The Charge indicator light (C) will illuminate RED when charg-ing. The light will turn GREEN when charging is complete. TheBattery Pack will not charge if the slide switch is OFF.Note: If no light illuminates on the Battery Pack, check theBattery Switch is slid to ON, the charger plug is firmly con-nected into the Battery Pack, and the AC charger is fully in-