DRAINAGE INSTALLATIONDRAINAGE WITH THE BUILT-IN WATER TANKThe unit is designed to use the built-in water tank for drainage bydefault. When the tank is full, the screen will display “FULL” and alsomake a buzzing sound.1. Press the POWER button to turn off the machine.2. To empty the water tank, open the front panel to access thewater tank.3. Grab the handle of the water tank and pull it out horizontally.4. After disposing of the water, insert the tank back into place untilyou feel the internal clamp fully clamp onto the nozzle of thetank. Close the front panel.5. Press the POWER button to resume operation.CONTINUOUS DRAINAGE WITH THE DRAINAGE PIPEIn extremely wet conditions, the water tank may be filled up frequently. You may consider setting upcontinuous drainage by using the drainage pipe for convenience.1. Open the front cover of the machine, remove the tank, and empty the water from the tank.2. Screw the water pipe connector off the water tank outlet. Set the connector aside.3. The outlet at the side of the water tank is sealed by default for drainage. If you decide to install apipe for continuous drainage, use a power tool to drill the side outlet so you to have an openingof sufficient size to allow water to drain through smoothly.4. Screw the connector back to the outlet tightly. A washer is pre-installed into the connector toprevent leakage.5. Install the included drain pipe to the water pipe connector on the tank, through the opening onthe machine housing. Direct the pipe to the desired area before operating the machine.6. If needed to replace or extend the drainage pipe, use 7/16" (ID Ф11 mm) piping.7. Shut the front panel.WARNING: Do not block the drainage pipe. The endof the drainage pipe should not be higher than thewater tank outlet. If the drainage pipe end is higherthan the outlet, water will not drain properly andcould damage components of the unit.Water tankOutlet at theside of watertankWater pipeconnectorOpeningfor drainpipeContinuousdrain pipe6