Manuals database logo
manualsdatabase
Your AI-powered manual search engine

AcuRite ENC 150 Reference Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Contents
  1. Introduction
  2. Mounting Preparation
  3. Mounting Information
  4. Encoder Dimensions
  5. Backup Spar Dimensions
  6. Mounting Requirements
  7. Typical Mounting (s)
  8. Encoder Installation Procedure
  9. Checking your Installation
  10. Electrical Shielding
  11. Troubleshooting
  12. Mechanical Specifications
  13. Output Signals and Pin-Outs
  14. Electrical Specifications
AcuRite ENC 150 Reference Manual Manual pdf 8 page image
Mounting options can be adapted to machine mounting surfacesusing spacers, standoffs, or leveling set screws.• Measuring length and mechanical configuration of your machinedetermine your options.• Backup spar mounting is an option but not required for lengthsup to 60”.• Fastener lengths described on this page are included with theencoder or the backup spar.• Less than 24” : Use end mounting holes. • Over 60” : A backup spar is required.7 ACU-RITE ®ENC150 Mounting Requirements1/4-20 x 1” BHCS& scale washer(supplied)End hole mounting1/4-20 x 1/2” BHCSand spar washer(supplied)Backup sparmounting• 24” to 60” : Use end mounting holes with center support..94 [23.8]1/4-20 x 1” BHCSTypical (supplied)1/4-20 x 3/4”SHCS LinearEncoderwasherCentersupportEnd hole mountingwith center supportM4 x 8mmSHSS
/ 22
This manual is suitable for:
ENC 150
Manuals database logo
manualsdatabase
Your AI-powered manual search engine