Chapter 7: Installing the Driver and an Operating System ● 354 Insert the driver disk, then wait until you are prompted to install a driver.5 Press S to specify that the driver is on a floppy disk, then press Enter.The computer reads the disk.6 When the Adaptec SAS driver is found, press Enter.7 Follow the on-screen instructions to complete the installation.8 Continue with Managing Your Storage Space on page 40.Installing with Red Hat LinuxYou will need your Red Hat Installation CD to complete this task. To install the HostRAIDcontroller driver while installing Red Hat Linux:1 Insert the first Red Hat Installation CD.2 Restart your computer.3 When the Red Hat Welcome screen displays, type linux dd at the Boot: prompt.4 When prompted, insert the driver disk, then select OK.5 Follow the prompts to set up the environment you want.6 If you are installing other third-party devices, install them now. Otherwise, select Done.7 Complete the Red Hat Linux installation, following the instructions included with youroperating system.8 Continue with Managing Your Storage Space on page 40.Installing with SuSE LinuxTo install the HostRAID controller driver while installing SuSE Linux:1 Insert the first SuSE Installation CD.2 Restart your computer.3 When the SuSE installation selection screen displays, do the following:● For UL 1.0—press the Alt key to have it prompt for a driver disk, select installation optionfrom the Menu, then press Enter.● For SLES 9, SuSE 9.x and 10—press the F6 key, select installation option from the Menu,then press Enter.4 When prompted, insert the driver disk, then press any key to continue.5 Follow the prompts to set up the environment you want.6 If you are installing other third-party devices, install them now. Otherwise, select Back.7 Complete the SuSE Linux installation, following the instructions included with youroperating system.8 Continue with Managing Your Storage Space on page 40.