Adaptec ARO-1130SA Installation And Hardware Manual

Also see for ARO-1130SA: Specifications

Contents

Adaptec ARO-1130SA Installation And Hardware Manual Manual pdf 19 page image

2-5Installing ARO-1130SA HardwareConnecting the LED Cable to the ARO-1130SA(Optional feature) An LED on the front panel of most computerslights to indicate non-SCSI hard disk activity. If you would like thatLED to light whenever there is activity on SCSI Channel A (con-trolled by ARO-1130SA), disconnect the LED cable from the mother-board and connect it to the LED connector on the ARO-1130SA. Ifthe LED has a two-position cable, connect the cable to pins 1 and 2 ofthe LED connector, as shown in Figure 2-4.If the ARO-1130SA supports multiple SCSI channels, and you wantthe LED to light whenever there is activity on any of those channels,refer to your motherboard documentation for instructions on settingthe appropriate motherboard jumpers.Note: If you are using non-SCSI disk drives (e.g., IDE), theLED may no longer indicate activity on these drives whenyou connect the LED cable to the ARO-1130SA.1Figure 2-4. Connecting the LED Activity Indicator CableLED CableLED Connector onARO-1130SA2-pin LED Cable11