Chapter 2: Using the Command Line Utility ● 16arcconf getversionLists version information for all controllers or a specific controller’s software components,including information about the BIOS, driver, firmware currently running, and firmware thatwill run after a reboot.Note: The firmware version that will run after a reboot is called the “staged” firmware.SyntaxARCCONF GETVERSION (use this for information on all controllers)ARCCONF GETVERSION (use this for information on a specificcontroller)ParametersController# is the controller numberExampleARCCONF GETVERSIONarcconf identifyIdentifies a physical or logical device by blinking its LEDs.SyntaxARCCONF IDENTIFY LOGICALDRIVE ARCCONF IDENTIFY DEVICE ParametersController# is the controller numberLogicalDrive# is the number of the logical drive to be identifiedChannel# is the channel number for the device to be identifiedDevice# is the device number for the device to be identifiedExampleARCCONF IDENTIFY 1 DEVICE 0 0ARCCONF IDENTIFY 1 ALLarcconf keyLoads a feature key onto an Adaptec controller.SyntaxARCCONF KEY SET ParametersController# is the controller numberKey# is the key number provided by AdaptecExampleARCCONF KEY 1 SET ABCD EFGH IJKL MNOP QRST UVWX