Adaptec RAID 21610SA Installation And User Manual

Also see for 2410SA - Serial ATA RAID Controller: Installation guide Installation and user guide Software reference guide Hardware installation guide

Contents

Adaptec RAID 21610SA Installation And User Manual Manual pdf 32 page image

3-7Installing the DriverUnixWare and OpenUNIXAlthough the driver disk you create for UnixWare 7.1.1 andOpenUNIX 8 differ, the installation procedures for these operatingsystems are the same.Installing the Driver on a New SystemIn this scenario, you are installing the controller in a newUnixWare 7.1.1 or OpenUNIX 8 system.To install the driver:1 Install and configure the controller and hard disk drivesaccording to the instructions in Chapter 2.Early in the operating system installation, you are shown awindow labeled Choose One.2 Insert the driver disk, select Install HBA diskette and thenpress F10.The driver loads from the driver disk. Then, the HBA screen isdisplayed.3 Select Proceed with Installation and then press F10.4 Complete the installation as appropriate.5 When the installation is finished, remove the driver disk andrestart the system.Adding the Driver to an Existing SystemIn this scenario, you are adding the driver to an existingUnixWare 7.1.1 or OpenUNIX 8 system.To install the driver:1 Shut down the computer. Install and configure the controllerand hard disk drives according to the instructions in Chapter 2.2 Turn on the computer. Then, insert the driver disk.3 To run the pkgadd utility, type pkgadd -d diskette1 and thenpress Enter. UNIX reads the disk and package information.4 Press Enter.5 Restart the system. The system rebuilds the kernel automatically.6 Add devices to the controller.