2Plugging in Your XHub4Follow the picture to connect your XHub4. You don’t haveto power off your computer before connecting the hub.Note: To ensure that all your USB devices operateproperly, Adaptec recommends that you alwaysconnect your XHub4 to a power source.(To power source)Step 1:Plug the XHub into theUSB port on your laptop ordesktop computer. (Thelocation of your availableUSB port may differ fromwhat’s shown in thisexample.)Step 2:Plug the poweradapter into theXHub’s Power port.(See Note below.)

before you begin

plugging in your xhub

plugging in your devices

troubleshooting

Adaptec XHub4 Quick Start Manual

system requirements

this is your xhub

installing drivers

understanding the leds

daisy-chaining xhubs

about usb

technical specifications

XHub4 - Hub - USB

Introduction

This Is Your Hub

port details

Plugging in Your Hub

Plugging in Your Devices

Organizing Your Cables (Plus models only)

Stacking Your Hubs

Removing the Desk Stand (Plus models only)

Personalizing Your Adaptec XHub

What's On the CD

Technical Specifications