Adeunis RF sigfox RC1 ANALOG ARF8191BA User Manual

Contents

Adeunis RF sigfox RC1 ANALOG ARF8191BA User Manual Manual pdf 55 page image

ENsigfox RC1 ANALOG - Guide utilisateur / User guide version V2.0.155Page of 86FR2. PRODUCT OPERATION2.1. Global OperationImportant: adeunis® use the most significant byte first format.The product has several operating modes:2.1.1 PARK modeThe product is delivered in PARK mode, it is in standby mode and its consumption is minimal. To switch the prod-uct out of the Park* Mode pass a magnet across it for a duration higher than 6 seconds. The green LED illuminatesto indicate the detection of the magnet and then flashes quickly during the product starting phase.The device then sends its configuration and data frames (see paragraph 4.1).2.1.2 COMMAND modeThis mode allows the user to configure the registers of the product.To enter this mode, connect a cable to the micro-USB port of the product and enter the command mode by an ATcommand (see paragraph 3).2.1.3 OPERATING modeThere are two possible modes of operation:• TEST mode:This mode allows the user to perform tests of the product more quickly by reducing the time scales of productionmode and modifying the behavior of the LEDs (see paragraph 2.2.5). WARNING : this mode has an highly im-pact on the device autonomy• PRODUCTION mode:This mode allows the user to operate the product in its final use. It should allow a maximum of autonomy to theproduct.To switch from one mode to the other the user changes the value of a registerPARK MODEOPERATING MODEREPLI MODECOMMAND MODEReplacing the batteryCommand sen-ding by serial linkPresence of a magneton the product >6sPresence of a magneton the product >6sAutomatic if batterytoo lowPRODUCTION MODETEST MODECOMMAND MODECOMMAND MODEThe return to theproduction modeis done by the ATOcommand or by dis-connecting the USBcable.