11 AIMB-580 User ManualChapter 1 General Information1.10 Rules for Populating Memory SlotsIn all modes, the frequency of system memory is the lowest frequency of all memorymodules placed in the system, as determined through the SPD registers on the mem-ory modules. The system memory controller supports one or two DIMM connectorsper channel. For dual-channel modes both channels must have at least one DIMMconnector populated and for single-channel mode only a single-channel may haveone or both DIMM connectors populated.Note! DIMMA1 must always be populated within any memory configuration.DIMMA1 is the furthest DIMM within a channel and is identified by theCS#[1:0], ODT[1:0], and CKE[1:0] signals.1.11 Memory Installation ProceduresTo install SDRAM, first make sure the two handles of the socket are in the “open”position. i.e. The handles lean outward. Slowly slide the module along the plasticguides on both ends of the socket. Then press the module right down into the socket,until you hear a click. This is when the two handles have automatically locked thememory module into the correct position of the socket. To remove the memory mod-ule, just push both handles outward, and the memory module will be ejected by themechanism in the socket.1.12 Cache MemoryThe AIMB-580 supports a CPU with one of the following built-in full speed L2 caches: 8 MB for Intel Core i7 CPU 8 MB for Intel Core i5-700 CPU 4 MB for Intel Core i5-600 CPU 4 MB for Intel Core i3 CPU 3 MB for Intel Pentium CPUThe built-in second-level cache in the processor yields much higher performancethan conventional external cache memories.1.13 Processor InstallationThe AIMB-580 is designed for LGA1156, Intel Core i7/Core i5/Core i3/Pentiumprocessor.
