v DSD-3000 Series User ManualSafety Instructions1. Read these safety instructions carefully.2. Retain this user manual for future reference.3. Disconnect this equipment from all AC outlets before cleaning. Use only a dampcloth for cleaning. Do not apply liquid or spray detergents.4. Pluggable equipment should be located near an easily accessible power outletsocket.5. Protect this equipment from humidity.6. Position this equipment on a reliable surface during installation. Dropping or let-ting the equipment fall may cause damage.7. The openings in the enclosure are for air convection to protect the equipmentfrom overheating. Do not cover these openings.8. Ensure that power source voltage is correct before connecting the equipment toa power outlet.9. Position the power cord away from high-traffic areas. Do not place anything overthe power cord.10. All cautions and warnings on the equipment should be noted.11. If unused for a long time, disconnect the equipment from the power source toavoid damage from transient overvoltages.12. Never pour liquid into the openings. This may cause fire or electrical shock.13. Never open the equipment. For safety reasons, the equipment should only beopened by qualified service personnel.14. If one of the following occurs, have the equipment checked by service person-nel:ļ®ļ The power cord or plug is damaged.ļ®ļ Liquid has penetrated into the equipment.ļ®ļ The equipment has been exposed to moisture.ļ®ļ The equipment is malfunctioning, or does not operate according to the usermanual.ļ®ļ The equipment has been dropped and damaged.ļ®ļ The equipment shows obvious signs of breakage.15. Do not leave this equipment in an environment with a storage temperature ofbelow -20 Ā°C (-4 Ā°F) or above 60 Ā°C (140 Ā°F). This may damage the equipment.The equipment should be stored in a controlled environment.16. There is a risk of a new battery exploding if incorrectly installed. Do not attemptto recharge, force open, or heat the battery. Replace the battery only with thesame or equivalent type recommended by the manufacturer. Discard used bat-teries according to the manufacturer's instructions.The sound pressure level at the operatorās position does not exceed 70 dB (A), asper the IEC 704-1:1982 specifications.DISCLAIMER: These instructions are provided in accordance with the IEC 704-1standard. Advantech disclaims all responsibility for the accuracy of any statementscontained herein.