Advantech EPC-U2117 User Manual

Contents

EPC-U2117 User Manual viSafety Instructions1. Please read these safety instructions carefully.2. Please keep this User’s Manual for later reference.3. Please disconnect this equipment from AC outlet before cleaning. Use a dampcloth. Don’t use liquid or sprayed detergent for cleaning. Use moisture sheet orclothe for cleaning.4. For pluggable equipment, the socket-outlet shall near the equipment and shallbe easily accessible.5. Please keep this equipment from humidity.6. Lay this equipment on a reliable surface when install. A drop or fall could causeinjury.7. The openings on the enclosure are for air convection hence protecting theequipment from overheating. DO NOT COVER THE OPENINGS.8. Make sure the voltage of the power source when connecting the equipment tothe power outlet.9. Ensure to connect the power cord to a socket-outlet with earthing connection10. Place the power cord such a way that people cannot step on it. Do not placeanything over the power cord.11. All cautions and warnings on the equipment should be noted.12. If the equipment is not used for long time, disconnect the equipment from mainsto avoid being damaged by transient over-voltage.13. Never pour any liquid into ventilation openings; this could cause fire or electricalshock.14. Never open the equipment. For safety reasons, only qualified service personnelshould open the equipment.15. Before any internal installation procedures are carried out on the system, makesure the system is turned off and cooled down for 15 minutes. Failing to run offthe system before opening it can cause permanent damage to the system andserious or fatal injury to the user.16. If one of the following situations arises, get the equipment checked by servicepersonnel:The power cord or plug is damaged.Liquid has penetrated into the equipment.The equipment has been exposed to moisture.The equipment does not work well, or you cannot get it to work according tothe user's manual.The equipment has been dropped and damaged.The equipment has obvious signs of breakage.17. Do not leave this equipment in an environment where the storage temperaturemay go below -40° C (-40° F) or above 85° C (185° F). This could damage theequipment. the equipment should be in a controlled environment.18. Caution: Danger of explosion if battery is incorrectly replaced. Replace only withthe same or equivalent type recommended by the manufacturer, discard usedbatteries according to the manufacturer's instructions. Risk of explosion if the battery is replaced by an incorrect type Replacement of a BATTERY with an incorrect type that can defeat a SAFE-GUARD (for example, in the case of some lithium BATTERY types); Disposal of a BATTERY into fire or a hot oven, or mechanically crushing orcutting of a BATTERY, that can result in an EXPLOSION;