Advantech ITA-1711 Series User Manual

Also see for ITA-1711 Series: Startup manual

Contents

Advantech ITA-1711 Series User Manual Manual pdf 17 page image

7 ITA-1711 User ManualChapter 2 H/W Installation2.3 Jumpers and Connector2.3.1 Jumper DescriptionYou may configure the ITA-1711 to match the needs of your application by settingjumpers. A jumper is a metal bridge used to close an electric circuit. It consists of twometal pins and a small metal clip (often protected by a plastic cover) that slides overthe pins to connect them. To close a jumper, you remove the clip. Sometime a jumperwill have three pins, labelled 1, 2 and 3. In this case you would connect either pins 1and 2, or 2 and 3.The jumpers setting are schematically depicted in this manual as follows.A pair of needle-nose pliers may be helpful when working with jumpers. If you haveany doubts about the best hardware configuration for your application, contact yourlocal distributor or sales representative before you make any changes. Generally, yousimply need a standard cable to make most connections.Open Closed 2-3 Closed断开闭合闭合 2-3Open Closed 2-3 Closed