Aviom A-16R User Manual

Also see for A-16CS: User guide

Contents

Aviom A-16R User Manual Manual pdf 82 page image

Aviom A-16 Personal Monitor Mixing System72TroubleshootingBefore contacting Customer Service, check the following list of common problemsand solutions for help.Problem: No audio from the Personal Mixer outputsPossible Solutions:• No input audio from the main mixing console. Check the levels of themain mixing board that the system is connected to.• Check the cables and connections between the main mixer and theA-16 system. The Signal LEDs on the front of the A-16T can be usedto confirm that audio is being received.• Bad cables; try a replacement.• All Channels on the Personal Mixer are at zero.• Master volume level on the Personal Mixer is at zero.• A-Net cables are not connected properly.Problem: Can’t change PresetsPossible Solutions:• Make sure that the R ECALL button has been pressed. Its LED willflash, indicating that you should press a numbered button to recall aPreset.Problem: Can’t hear a Channel that is part of a GroupPossible Solutions:• The Group might be muted. Check the lower (yellow) LED in theChannel buttons. A lit yellow LED indicates the Channel is muted.To unmute it, press the M UTE button while the Group is selected. Theyellow LED must be unlit in order to hear the audio on that channel.• The Channel volume is all the way down. In Group edit mode, selectthe Channel and check the level for that Channel by looking at theLEDs in the Volume indicator. If no LEDs are lit, then the Channelis turned all the way down. Raise the volume by turning the ChannelVOLUME knob; re-save the Group and Preset if necessary.Problem: The A-Net LED is on, but there is no soundPossible Solutions:• The A-Net Active LED indicates that the input to the receiving deviceis properly connected to another A-Net device. It does not indicate thatall devices in a system are properly connected, however. If you have