Axis 0530-001 User Manual

Also see for AXIS P1357-E: User manual User manual Installation guide Installation guide Installation guide

AXIS P1357–E Network CameraAccessing the ProductThe Play button connects to the Axis product and starts playing a media stream.The Stop button stops the media stream.The Snapshot button takes a snapshot of the video image. The location where the image is saved can be specifiedin the AMC Control Panel.Click the View Full Screen button and the video image will fill the entire screen. Press ESC (Escape) on the computerkeyboard to cancel full screen view.The Record button is used to record the current video stream. The location where the recording is saved can be specified inthe AMC Control Panel. Enable this button from Live View Config > Viewer Settings.AMC Audio ControlsAMC audio buttons control the speakers and microphone connected to the client computer. The buttons are only visible whenaudio is enabled.Speaker button — Click to turn the speakers on or off.Microphone button – Click to mute or unmute the microphone. In Simplex - speaker only mode, the Microphone and Talkbuttons must both be active to send audio to the Axis product. Click either button to stop audio transmission.Use the slider to control the volume of the speakers and the microphone.Half-duplex modeThe Talk/Listen button is used to switch between sending and receiving audio. The button can be configuredfrom the Audio tab in the AMC Control panel:• Push-To-Talk mode: Click and hold the button to talk/send. Release the button to listen.• Toggle mode: Click once to switch between talking and listening.Simplex – speaker only modeTo send audio, the Talk and Microphone buttons must both be active. Click either button to stop audiotransmission.PTZ ControlsThe Live View page also displays Pan/Tilt/Zoom (PTZ) controls. The administrator can enable/disable controls for specified users underSystem Options > Security > Users.With the PTZ Control Queue enabled the time each user is in control of the PTZ settings is limited. Click the buttons to request orrelease control of the PTZ controls. The PTZ Control Queue is set up under PTZ > Control Queue.Click the Emulate joystick mode button and click in the image to move the camera view in the direction of themouse pointer.Click the Center mode button and click in the image to center the camera view on that position. The center modebutton could also be used to zoom in on a specific area. Click in the image and drag to draw a rectangle surroundingthe area to be magnified. To zoom out, rotate the mouse wheel.Click the Ctrl panel button to open the PTZ control panel which provides additional PTZ controls.User-defined buttons can also appear in the Control panel. See Controls, on page 33.15