Axis 207 Installation Manual
Also see for AXIS 207: User manualSpecificationsProduct guideInstallation guideSpecification
                                           | |
Contents
| 
Page 10 AXIS 207 Installation GuideAccessing the AXIS 207 from the InternetOnce installed, a camera is accessible on your local network (LAN). To access the camera fromthe Internet you must configure your broadband router to allow incoming data traffic to thecamera. One method for this is NAT traversal via port mapping.For more information, please refer to the AXIS 207 User’s Manual which is available on the CDincluded in this package and from the Axis Web site at http://www.axis.com.See also the AXIS Internet Dynamic DNS Service at www.axiscam.netResetting to the Factory Default SettingsThis will reset all parameters, including the IP address, to the Factory Default settings:1. Disconnect power from the AXIS 207.2. Press and hold the Control button and reconnect power.3. Keep the button pressed until the Status Indicator displays yellow (this may take up to 15seconds), then release the button.4. When the Status indicator displays green (which can take up to 1 minute) the AXIS 207 isreset to the factory default settings.5. Re-install the AXIS 207 using one of the methods described in this document.More informationFor more information, please see the AXIS 207 User’s Manual, which is available on the CDincluded in this package. Updated versions can be obtained from www.axis.com |
Related manuals for Axis AXIS 207
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine