AXIS 207/207W/207MW Installation Guide Page 9ENGLISHNotes:• To open a command prompt in Windows: from the Start menu, select Run... and type cmd(or command in Windows 98/ME). Click OK.• To use the ARP command on a Mac OS X, use the Terminal utility, which is found under Applications > Utilities• Set the IP address within 2 minutes of starting the camera.AXIS Internet Dynamic DNS ServiceThe AXIS Internet Dynamic DNS Service is a free service provided by Axis, which allows youto quickly and simply install your camera, which then receives a static DNS name. Moreinformation about the AXIS Internet Dynamic DNS Service is available at www.axiscam.netTo perform this procedure, your network should have an Internet connection with no HTTPproxy, and IP addresses should preferably be assigned via DHCP.Follow these instructions:1. After making the connections for network and power, wait for the Status indicator to showa steady green.2. Press the Control button once. The Status indicator flashes green while it connects to theAXIS Internet Dynamic DNS Service.3. Wait for the Status indicator to go back to showing a steady green.4. To complete the installation, now visit www.axiscam.net from an Internet connectedcomputer. This must be done within 60 minutes of pressing the Control button.5. Follow the on-screen instructions provided by the AXIS Internet Dynamic DNS Service.You will need the product’s serial number to complete the installation. See page 3.See page 10 for instructions on how to set the password.Important!To remove the DNS name and unregister from this service, open the Setup pages in the AXIS207/207W/207MW, click System Options > Network > TCP/IP > Basic, click the Settingsbutton for the AXIS Internet Dynamic DNS Service and finally, click the Remove button.Please note that this procedure will send the IP address, firmware version, product type and serial numberof the AXIS 207/207W/207MW to the AXIS Internet Dynamic DNS Service. No personal information istransferred.