AXIS 2110 Installation Guide - English Page 2 of 5Verifying and Completing the Installation From Your BrowserTo access the AXIS 2110 Home Page, start your browser and enter the IP address in the location/address field, e.g. 171.21.1.200.Click the Installation Wizard link. The wizard guides you through the remaining installationprocedures and will help you configure your application. Detailed information on how to use thevarious product functions is conveniently provided in the on-line help, available from theconfiguration pages.Installing Your Camera via a ModemThe information in this section describes how to connect the AXIS 2110 to a serial modem fortransmitting images over a normal Dial-Up connection.Important!Connecting Your Computer Using the Null Modem CableFollow the steps below to configure a serial modem connection for your AXIS 2110:• The information and screen examples featured here are specific to Windows NT. Although similar tothe Dial-Up implementations in Windows 95, 98, and 2000, small deviations in the dialog instruc-tions for other operating systems should be expected. Refer to your system information for furtherinformation on creating a Dial-Up modem connection if you are using any other operating system.• Windows Dial-Up Networking and TCP/IP must be correctly installed prior to commencing with themodem cable connection. Detailed information on how to check this is provided in Windows Help.Connect the supplied Null modem cablebetween the COM1 Serial Connector on theAXIS 2110 and the COM port of your computer. From the Start menu, open the Con-trol Panel and click the Modems icon.Select the serial port to which yourAXIS 2110 is now connected via theNull Modem cable. Click Next>.If a Standard Modem is already set up anddisplayed in the Modem Properties dialog (seeright) you should proceed directly to step 8.Select the Standard 28800modem from the displayed list ofmodems. Click Next>.Click the Properties button to finally check that the dis-played Communications Port is set correctly; that is, set tothe same port you connected the AXIS 2110 to. Click OK. Connect the power supply to theAXIS 2110 and check that the PowerIndicator is lit.Click Close.Check the checkbox: Don’t detectmy modem, I will select it from a list.Click Next>.A Standard 28800 modem connection isnow available for the AXIS 2110. Click Finishto close the Install New Modem wizard.