Installing the AXIS 215 PTZ in the Videotec DBH24K Dome HousingInstalling the AXIS 215 PTZ in the Videotec DBH24K HousingThis document is an addendum to the Installation Kit for PTZ Camera (AXIS 2130R and AXIS 213)and the AXIS 215 PTZ Installation Guide and describes how to install an AXIS 215 PTZ NetworkCamera in the Videotec DBH24K Dome Housing. Please read through the supplied instructions beforeproceeding with the installation.Important!High voltage - the apparatus works on 230V AC. Always ensure that the power is disconnected before starting any work or opening thehousing. This product should be installed by certified electrical technicians in compliance with local laws and regulations. Use cableglands and cables that are suitable for external use and are in compliance with local laws and regulations.Before you beginThe following is needed to complete the installation:• Videotec DBH24K Dome Housing including:• wall/ceiling/pole mounting accessories• VT Dome Adapter AXIS 215 PTZ including:• bracket with heater and fan (AXIS 213/AXIS 215 PTZ)• bracket (AXIS 213/AXIS 215 PTZ)• adapter plate (AXIS 215 PTZ)• double sided adhesive tape• 2 M5x8 screws• 4 M4x6 screws• AXIS 215 PTZ Network Camera including:• power adapter• Additional hardware requirements (not supplied):• Standard mains power cable• a standard network cable• conduits suitable for the intended installation• plugs and screws suitable for the wall material and for the weight of the camera and housingNote: Part numbers and details are available from the Axis website at www.axis.com1. Follow the instructions in the Installation Kit for PTZ Camera (AXIS 2130R and AXIS 213) toassemble the housing.Note: This information also applies to the AXIS 215 PTZ2. Follow the instructions below to continue the installation of the AXIS 215 PTZ and brackets in thehousing.Part no. 28437