Axis 216FD User Manual

Also see for Axis 216FD: Installation guide Specifications Product guide User manual User manual

Axis 216FD User Manual Manual pdf 44 page image

44AXIS 216FD/FD-V - System OptionsBonjourThe AXIS 216FD/FD-V/MFD/MFD-V includes support for Bonjour. When enabled, thecamera is automatically detected by operating systems and clients that support this.RTP / MPEG-4These settings are the port range, IP address, port number (video and audio), andTime-To-Live value to use for the video stream(s) in multicast MPEG-4 format. Onlycertain IP addresses and port numbers should be used for multicast streams. For moreinformation, please see the online help.Ports & DevicesI/O Ports - the pinout, interface support and the control and monitoring functionsprovided by this connector are described in The I/O Terminal Connector, on page 47.LED SettingsThe Status indicator LED on the front of the camera can be set to flash at a configurableinterval (or to not light up at all) whenever the unit is accessed. For a listing of all LEDbehavior, see page 9, or the online help. Note that the LED does not flash when the streamis retrieved using MPEG-4 multicast.Maintenance• Restart - The camera is restarted without changing any of the settings.• Restore - The unit is restarted and most current settings are reset to factory default val-ues. The settings that will not be reset are as follows:• the boot protocol (DHCP or static)• the static IP address• the default router• the subnet mask• Default - The default button should be used with caution. Pressing this will return all ofthe camera's settings to the factory default values (including the IP address)Upgrade Server - See Upgrading the Firmware, on page 49.Backup - To take a backup of all of the parameters, and any user-defined scripts, click thisbutton. If necessary, it will then be possible to return to the previous settings, if settings arechanged and there is unexpected behavior.Restore - click the Browse button to locate the saved backup file (see above) and then clickthe Restore button. The settings will be restored to the previous configuration.Note: Backup and Restore can only be used on the same unit running the same firmware. This feature is notintended for the configuration of multiple units or for firmware upgrades.