Page 6 AXIS 231D/232D Installation GuideExterior Ceiling MountingmoduleDecorationringNetworkConnectionconnectorNetworkIndicatorPowerIndicatorfixing screwMounting slot forControlbuttonconnectorSerial numberS/NFollow these instructions to mount the dome camera:1. Using the supplied drill template, drill three holes in the ceiling and secure the bracket tothe ceiling with three screws.2. Connect the connection module cable to theconnection module.3. Connect the Ethernet cable and connection moduleto the AXIS 231D/232D.4. Connect the power cable (24V AC) to theconnection module and check that the power andnetwork LEDs light up green.5. Mount the dome body onto the bracket and rotateit clockwise. Make sure the screw hole on the sideof dome is aligned with the bracket. Tighten thefixing screw to secure the dome.6. Attach and secure the decoration ring to the bracket.7. The hardware installation is now complete, proceed to Setting the IP address, on page 8to install the AXIS 231D/232D on your network.24V ACPS GND not usedConnection module cable connector
