6 AXIS 291 1U Video Server RackConnect powerPlease ensure that the correct AC power cord for your country is used.The AXIS 291 has no On/Off switch or button, and will power up as soon as the AC power cord is connected. Itis important to locate the unit so that the AC power cord is easily accessible. Detaching the cord is the onlyway to remove power to the unit.To prevent the risk of electrical shock when in contact with the unit casing, only earthed/grounded powercords should be used to power the AXIS 291.The AXIS 291 Video Rack Server is designed for use with Axis Blade Video Servers only.If a foreign object is accidently dropped into the Video Rack Server, always disconnect power beforeattempting to remove the object.Power specifications• Input voltage 100-240V AC, at 50/60Hz• Input current: 1.9A• Power consumption with 3 x AXIS 243Q: Max 80WAXIS blade video serversThe S/N (serial number) is identical to the unit’s MAC/Ethernet address,e.g. 00408C1A2B3C = 00-40-8C-1A-2B-3C. P/N is the product’s model number.Bus Connector- This is the physical interface to the I/O terminal connector on the rack.DIP Switches (4-port models) - Each video input has a corresponding line termination DIP switch. Axis bladevideo servers are supplied with the line termination enabled for each input; that is, with the DIP switches set toON (down position).To connect the video server in parallel with other equipment, disable the input termination by setting thecorresponding DIP switch to OFF (Up position). Failure to do so may affect the image quality negatively.BusConnectorDIP SwitchesS/N & P/N label4 Video inputs