AXIS 7000/FX Userís Manual Basic Installation 19Connecting Digital Copiers and ScannersImportant!Connecting the AXIS 7000/FX to your scanner or digital copier:1. Switch off the scanning device and disconnect the AXIS 7000/FXexternal power supply.2. Connect the SCSI cable to the SCSI connector on the AXIS 7000/FX.3. Connect the SCSI cable to the scanning device. The AXIS 7000/FXuses a built-in SCSI terminator. Note that the scanning device mustalso be terminated properly. Refer to the documentation suppliedwith your scanner or digital copier.ï Check that the power supply provided with your AXIS 7000/FX is marked with the correctmains voltage.ï Make sure the scanning device is switched off and the AXIS 7000/FX power supply is discon-nected. The SCSI bus may become damaged if you connect or disconnect units when power ison.
