Axis M3007–P User Manual

Also see for M3007-P: Technical specifications Installation guide User manual User manual Installation guide

AXIS M3007–PSystem Options2. Click Install certificate and upload the certificate.Date & TimeThe Axis product’s date and time settings are configured under System Options > Date & Time.Current Server Time displays the current date and time (24h clock). The time can be displayed in 12h clock in the text overlay (seebelow).To change the date and time settings, select the preferred Time mode under New Server Time:• Synchronize with computer time sets date and time according to the computer’s clock. With this option, date andtime are set once and will not be updated automatically.• Synchronize with NTP Server obtains date and time from an NTP server. With this option, date and time settings areupdated continuously. For information on NTP settings, see NTP Configuration, on page 44.If using a host name for the NTP server, a DNS server must be configured. See DNS Configuration, on page 44.• Set manually allows you to manually set date and time.If using an NTP server, select your Time zone from the drop-down list. If required, check Automatically adjust for daylight savingtime changes.The Date & Time Format Used in Images is the date and time format displayed as a text overlay in the video stream. Use thepredefined formats or see File Naming & Date/Time Formats in the online help for information on how to create custom date andtime formats. To include date and time in the overlay text, go to Video and select Include date and Include time.NetworkBasic TCP/IP SettingsThe Axis product supports IP version 4 and IP version 6. Both versions can be enabled simultaneously, and at least one versionmust always be enabled.IPv4 Address ConfigurationBy default, the Axis product is set to use IPv4 (IP version 4) and to obtain the IP address automatically via DHCP. The IPv4 settings areconfigured under System Options > Network > TCP/IP > Basic.DHCP (Dynamic Host Configuration Protocol) allows network administrators to centrally manage and automate the assignment ofIP addresses. DHCP should only be enabled if using dynamic IP address notification, or if the DHCP can update a DNS server. It isthen possible to access the Axis product by name (host name).If DHCP is enabled and the product cannot be accessed, run AXIS IP Utility to search the network for connected Axis products, or resetthe product to the factory default settings (see page 50) and then perform the installation again.To use a static IP address, check Use the following IP address and specify the IP address, subnet mask and default router.IPv6 Address ConfigurationIf IPv6 (IP version 6) is enabled, the Axis product will receive an IP address according to the configuration in the network router.To enable IPv6, go to System Options > Network > TCP/IP > Basic. Other settings for IPv6 should be configured in the network router.ARP/PingThe product’s IP address can be assigned using ARP and Ping. For instructions, see Assign IP Address using ARP/Ping, on page 43.42