Axis M3007–P User Manual

Also see for M3007-P: Technical specifications User manual Installation guide User manual Installation guide

AXIS M3007–PTroubleshootingTroubleshootingCheck the FirmwareFirmware is software that determines the functionality of network devices. One of your first actions when troubleshooting a problemshould be to check the current firmware version. The latest version may contain a correction that fixes your particular problem. Thecurrent firmware version in the Axis product is displayed in the page Setup > Basic Setup and in Setup > About.Upgrade the FirmwareImportant• Your dealer reserves the right to charge for any repair attributable to faulty upgrade by the user.• Preconfigured and customized settings are saved when the firmware is upgraded (providing the features are available in thenew firmware) although this is not guaranteed by Axis Communications AB.Note• After the upgrade process has completed, the product will restart automatically. If restarting the product manually after theupgrade, always wait 10 minutes even if you suspect the upgrade has failed.• When you upgrade the Axis product with the latest firmware from Axis website, the product receives the latest functionalityavailable. Always read the upgrade instructions and release notes available with each new release before upgradingthe firmware.To upgrade the product’s firmware:1. Save the firmware file to your computer. The latest version of the firmware is available free of charge from Axis websiteat www.axis.com/techsup2. Go to Setup > System Options > Maintenance in the product’s webpages.3. Under Upgrade Server, click Browse and locate the file on your computer. Click Upgrade.4. Wait approximately 10 minutes while the product is being upgraded and restarted. Then access the product.AXIS Camera Management can be used for multiple upgrades. See www.axis.com for more information.Emergency Recovery ProcedureIf power or network connection is lost during the upgrade, the process fails and the product becomes unresponsive. Flashing red Statusindicator indicates a failed upgrade. To recover the product, follow the steps below. The serial number is found on the product’s label.1. In UNIX/Linux, type the following from the command line:arp -s address> number> tempping -l 408 address>In Windows, type the following from a command/DOS prompt (this may require that you run the command prompt asan administrator):arp -s address> number>ping -l 408 -t address>2. If the product does not reply in 30 seconds, restart it and wait for a reply. Press CTRL+C to stop Ping.3. Open a browser and type in the product’s IP address. In the page that opens, use the Browse button to select the upgradefile to use. Then click Load to restart the upgrade process.4. After the upgrade is complete (1–10 minutes), the product automatically restarts and shows a steady green on theStatus indicator.54