Axis M3007-P User Manual

Also see for M3007-P: Technical specifications User manual Installation guide User manual Installation guide

AXIS M3007-P Network CameraHardware OverviewNONONOTICETICETICEThe product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shallbe intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer’sinstructions. For information about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2 .SD card slotNONONOTICETICETICE• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when inserting or removing theSD card. Use your fingers to insert and remove the card.• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Disconnect power orunmount the SD card from the Axis product’s webpages before removal.This product supports microSD/microSDHC/microSDXC cards (not included).For SD card recommendations, see www.axis.comControl ButtonFor location of the control button, see Hardware Overview on page 6 .The control button is used for:• Resetting the product to factory default settings. See page 57.• Connecting to an AXIS Video Hosting System service. See page 49. To connect, press and hold the button for about 3seconds until the Status LED flashes green.• Connecting to AXIS Internet Dynamic DNS Service. See page49. To connect, press and hold the button for about 3 seconds.LED IndicatorsNote• The Status LED can be configured to flash while an event is active.• The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance .Status LED IndicationUnlit Connection and normal operation.Green Shows steady green for 10 seconds for normal operation after startup completed.Amber Steady during startup. Flashes during firmware upgrade.Amber/Red Flashes amber/red if network connection is unavailable or lost.Red Flashes red for firmware upgrade failure.7