Axis M5000-G User Manual

Also see for M5000-G: Manual Installation guide

AXIS M5000-G PTZ CameraThe web interfaceAdd subscription: Click to add a new MQTT subscription.Subscription filter: Enter the MQTT topic that you want to subscribe to.Use device topic prefix: Add the subscription filter as prefix to the MQTT topic.Subscription type:• Stateless: Select to convert MQTT messages into a stateless message.• Stateful: Select to convert MQTT messages into a condition. The payload is used as the state.QoS: Select the desired level for the MQTT subscription.MQTT overlaysNoteConnect to an MQTT broker before you add MQTT overlay modifiers.Add overlay modifier: Click to add a new overlay modifier.Topic filter: Add the MQTT topic that contains the data you want to show in the overlay.Data field: Specify the key for the message payload that you want to show in the overlay, assuming the message is in JSON format.Modifier: Use the resulting modifier when you create the overlay.• Modifiers that start with #XMP show all of the data received from the topic.• Modifiers that start with #XMD show the data specified in the data field.StorageNetwork storageIgnore: Turn on to ignore network storage.Add network storage: Click to add a network share where you can save recordings.• Address: Enter the IP address or host name of the host server, typically a NAS (network-attached storage). Werecommend you to configure the host to use a fixed IP address (not DHCP since a dynamic IP address can change) orthat you use DNS. Windows SMB/CIFS names are not supported.• Network share: Enter the name of the shared location on the host server. Several Axis devices can use the samenetwork share since each device gets its own folder.• User: If the server requires a login, enter the username. To log in to a specific domain server, typeDOMAIN\username.• Password: If the server requires a login, enter the password.• SMB version: Select the SMB storage protocol version to connect to the NAS. If you select Auto, the device triesto negotiate one of the secure versions SMB: 3.02, 3.0, or 2.1. Select 1.0 or 2.0 to connect to older NAS that don’tsupport higher versions. You can read more about SMB support in Axis devices here.• Add share even if connection test fails: Select to add the network share even if an error is discovered during theconnection test. The error can be, for example, that you didn’t enter a password even though the server requires one.Remove network storage: Click to unmount, unbind, and remove the connection to the network share. This removes all settingsfor the network share.Unbind: Click to unbind and disconnect the network share.Bind: Click to bind and connect the network share.Unmount: Click to unmount the network share.Mount: Click to mount the network share.45