Axis M7016 Installation Manual

Also see for M7016: User manual User manual Installation guide

Contents

AXIS M7016 Video EncoderRS485/RS422 TX A 3RS485/RS422 TX B 4(TX) For full duplex RS485/RS422Install the HardwareMount the video encoderThe AXIS M7016 is supplied with a mounting kit containing brackets. The unit can be mounted ina rack or on a wall.After removing the existing 4 screws, attach the mounting brackets to the video encoder at anangle suitable for installation in a standard 1U 19” rack, or on the wall.Mounting on a wall1. Position the video encoder against the wall with the brackets attached, and mark thefour mounting holes, two for each bracket.2. Drill the four mounting holes.3. Attach the video encoder to the wall using appropriate screws.Connect the cables1. Connect the video encoder to the network using a network cable RJ45.2. Connect the cameras to the video inputs.3. Connect the supplied indoor power adapter.4. Check that the indicator LEDs indicate the correct conditions. See LED Indicators, onpage 8Access the ProductUse the tools provided on the Installation and Management Software CD to assign an IP address,set the password and access the video stream. This information is also available from the supportpages on www.axis.com/techsup/Reset to Factory Default SettingsImportantReset to factory default should be used with caution. A reset to factory default will resetall settings, including the IP address, to the factory default values.To reset the product to the factory default settings:11ENGLISH

/ 14

Related manuals for Axis M7016