Axis P5522–E User Manual

Also see for DROP CEILING P5522-E: Installation guide Installation guide User manual Datasheet Preventive Maintenance Instructions and Checklist

AXIS P5522–E PTZ Dome Network CameraSystem OptionsThe Axis product supports SD cards with up to 64 GB of storage. For best recording performance, use an SDHC or SDXC cardwith speed class 10.The following SD card file systems are supported:• ext4 — recommended due to its resilience against data loss if the card is ejected or if there is abrupt power loss. To accessdata stored on the card from the Windows operating system, a third-party ext4 driver or application is required.• vFAT — supported by most operating systems for personal computers.The SD card is managed on the System Options > Storage page. Click SD Card to open Storage Management.If the card’s status shows as failed, click Check disk to see if the problem can be found and then try Repair. This option is onlyavailable for SD cards with ext4. For SD cards with vFAT, use a card reader or computer to troubleshoot the card.To avoid filling the card, it is recommended to remove recordings continuously. Under General Settings, select Remove recordingsolder than and select the number of days or weeks.To stop writing to the card and protect recordings from being removed, select Lock under General Settings.Mount and Unmount SD CardNONONOTICETICETICETo prevent corruption of recordings, the SD card should always be unmounted before it is ejected.The SD card is automatically mounted when the card is inserted into the Axis product or when the product is started. A manualmount is only required if the card has been unmounted and not ejected and re-inserted.To unmount the SD card:1. Open the Axis product’s webpages and go to Setup > System Options > Storage.2. Click SD Card.3. Click Unmount.4. The card can now be removed.Format SD CardNONONOTICETICETICEFormatting the SD card will remove all data and recordings stored on the card.ImportantIf autoformat is enabled, only use new or empty SD cards. Any data stored on the card will be lost when the card is insertedinto the Axis product.An SD card inserted into the product can be manually formatted to one of the supported file systems. To manually format theSD card, follow these steps:1. Insert the SD card in the SD card slot.2. Open the Axis product’s webpages and go to Setup > System Options > Storage.3. Click SD Card.4. Click Format and select the desired file system.5. Click OK to start formatting the card.49