Axis Q19 series Installation Manual

Also see for Q19 Series: User manual Repainting instructions Repainting instructions User manual Installation guide

Contents

Page 12 AXIS Q19 Series Installation Guide5. Route the network cable through the cable gland.6. Press the gasket into the cable gland and screw the cap on firmly.Note:Using any other than the provided cable gland may cause water to seep in and damage theproduct. Cables must have a diameter of 4.0 mm - 5.5 mm.Attach the camera to the wall bracket1. Place the camera with the bottom cover on the bracket and tighten the bracket adapter screws.2. Replace the cable cover and tighten the screws.3. Connect the cables, see Connect the cables, on page 13.Note: If more than one cable is used, each cable must be routed through a separate cable gland, seeRoute the network cable through the cable hole, on page 11.4. Loosen the bracket adjustment screw to aim the camera to the point of interest and focus thecamera if required, see Focus adjustment - AXIS Q1921/-E/Q1922/-E, on page 19. See Access thevideo stream, on page 18, for information on how to view the video stream.5. Attach the safety wire to the tab on the bottom cover.6. Connect the window heater cable to the window heater connector on the camera.7. Attach the top cover to the bottom cover. Make sure to tighten diagonally opposite bottomcover screws a few turns at a time until all are tight. This will help ensure that the bottom covergasket is compressed evenly.8. Loosen the sunshield adjustment screws and adjust the sunshield to the desired position.Cable coverBracket adapter screw (4x)Cable cover screw (2x)Network cable (routeWall bracketBracket adjustment screwthrough wall bracket)Bottom coverSafety wire tabCable holes with cable glands