User ManualPage 12 of 42Configuring TCP/IP SettingsCheck if your computer uses the default TCP/IP settings.To check the TCP/IP properties:1. Select Start > Run. The Run dialog box would appear.2. Enter control ncpa.cpl on the input box, and then click the OK button.This would open the Network Connections window in your computer.3. Right-click LAN and then select Properties. The Local Area ConnectionProperties dialog box would appear.4. Select Internet Protocol (TCP/IP) and then click Properties. The InternetProtocol (TCP/IP) dialog box would appear.5. Select Obtain an IP address automatically.6. Click the OK button to close the Internet Protocol (TCP/IP) dialog box.7. Click the OK button to close the Local Area Connection Propertiesdialog box.Configuring Internet PropertiesTo set the Internet Properties:1. Select Start > Run. This opens the Run dialog box.2. Enter control inetcpl.cpl and then click OK to open the InternetProperties window.3. Click on the Connections tab.4. On the Dial-up and Virtual Private Network settings pane, select Neverdial a connection.5. Click OK to close Internet Properties.