B2 Audio Quattro Owner's Manual

Contents

B2 Audio Quattro Owner's Manual Manual pdf 5 page image

5CAUTIONPanel layoutQuattroCH2 CH1CH4 CH3SPEAKER OUTPUT FUSESConnection to the speakers leads. The amplifier is fused with 3 x 25A.Ensure polarity & corresponding channels are correct. Remember fusing has to be done atNB! Note the minimum bridged load. the battery as well!Connections below the stated will cause excessiveheat & the amplifier can go into thermal. REM (REMOTE)Continious thermal mode can cause damage & void Connect to switched +12V fromthe warranty. the headunit.+ 12V (POWER CONNECTION) GND (GROUND CONNECTION)Connects to the positive terminal of the battery (+12V). For connection to the chassis’ ground.For specified performance 4 GA cable is required. Keep as short as possible (< 50 cm / 20”).Fuses shall be placed within 20 cm / 8” of the battery. Use minimum 4 GA cable for specifiedperformance.Installation of the amplifier shall be done in the following steps:1. Ensure the ground is appropriate, then connected it to the amplifier. 2. Connect the +12V wire, keep in mind thiswire has to be fused at the battery as well. 3. Connect the switched remote. 4. Reattach negative wire (ground) tothe battery. 5. Operation over 15,5 V will cause the amplifier to go into protect & can void the warranty!GROUNDBATTERYHead unit