en19Washing dishesReduce costs!If only a small number ofdishes have been loaded intothe dishwasher, selecting aprogramme that operates atthe next lowest temperaturewill usually suffice.Programme specificationsThe programme specifications can befound in the summary of instructions.Programme specifications refer to normalconditions. Greater deviations may occurdue to:varying amounts of disheswater supply temperaturewater pipe pressureambient temperaturemains voltage tolerancesand the tolerances specificto the appliance (e.g. temperature,amount of water, etc.)The water consumption values referto a set water hardness value of 4.Aqua sensor ** on applicable modelsThe Aqua sensor is an optical measuringdevice which measures the turbidity of therinsing water. A light barrier can detectdissolved food remnants in the water, e.g.egg, fat and oats.The Aqua sensor is used according tothe programme. When the Aqua sensoris active, ”clean” rinsing water may betransferred into the next rinsing bathand/or the temperature adjusted. If theturbidity is greater, the water is drainedand is replaced with fresh water. In thisway the water consumption is reduced byapprox. 4 litres for utensils which are ”less”dirty.Switching the dishwasher ONTurn on the tap.Set main switch 1 to ON.Indicators light up according to the lastprogramme that was selected.This same programme will run again ifno other programme button 6 ispressed.The numerical display 3 shows theexpected duration of the programme.The programme starts automatically.Programme sequence indicator7Your dishes are being cleaned.Your dishes are being dried.Your dishes are being rinsed.End of programmeThe programme has ended when a figureappears in the numericaldisplay 3 .Switching the dishwasher OFFSeveral minutes after the programme hasended:Set the main switch 1 to OFF.Turn the water tap off.(Does not apply when Aqua-Stop unithas been fitted)Remove dishes, etc. when they havecooled down.