en23Pump ** on applicable modelsLarger remnants of food that have notbeen trapped by the filters and have beenleft in the water can cause a blockage inthe pump. The water is no longer pumpedout of the dishwasher and it can be seencovering the filter.Proceed as follows:First, always disconnect the appliancefrom the power supply.Ladle out as much water as possible.Remove the filters 25 .Undo the screw in the cover (Torx T 20)and remove the cover.Inspect the inside and remove anyobstructions that you find.Re-insert the cover and screw down.Re-insert the filters and screw down.Torx T202 1Fault findingResolving minor problemsyourselfExperience has shown that you canresolve most problems that arise duringnormal daily usage yourself, withouthaving to call out a service engineer. Notonly does this save costs, but it alsomeans that the appliance is available foruse again that much sooner. The followinglist of common occurrences and theirremedies should help you identify thecauses of most problems.Problems ...AttentionRemember: Repairs may becarried out by a technician only.If a component has to be replaced,ensure that only original spareparts are used. Improper repairsor use of non-original spare partsmay cause considerable damageand put the user at considerablerisk.... when the applianceis switched onThe appliance does not start.The mains fuse has tripped.The appliance plug has not beeninserted.The appliance door has not beenshut properly.The tap has not been turned on.