BANDELIN Sonoplus HD 2070 Instructions For Use Manual

BANDELIN Sonoplus HD 2070 Instructions For Use Manual Manual pdf 12 page image

1.5 Warning and safety precautionsGeneral• Keep the device and accessories out of the reach of children and also of persons who have notbeen instructed in their operation by reference to these instructions.• The use of the device or of its parts on humans or animals is not authorised.• Keep the HF generator and operating elements clean and dry.• Do not expose the unit to corroding forces.• When working with the device, please observe hygiene instructions pursuant to chapter 5.2.• The connection of any type of power or voltage sources to the signal inputs or outputs isforbidden.• Signal wires for foot switches, temperature sensors, etc., may not exceed a maximum length of3 m.• All plug connections (such as for ultrasonic transducers, foot switches) may only be plugged orunplugged while the device is turned off.• The HF generator and ultrasonic transducer must be transported separately.• The homogenisers HD 2070 and HD 2200 adhere to prescribed EMC limit values, so that itcan be assumed that the electromagnetic radiation emanating from the units is harmless tohumans. A binding statement for wearers of implants can only be made at the place of work andtogether with the implant manufacturer. In case of doubt, information regarding the allowableelectromagnetic exposure level is to be obtained from the implant manufacturer.Operation• Observe ambient and set-up conditions, see chapter 1.4.1.• Determine the local mains voltage before connecting the HF generator, activate the switch ifneeded.• Only connect the HF generator to a grounded socket.Fuse protection 10 A (main circuit breaker).• The ultrasonic transducer should only be firmly mounted on the black housing using a suitablesupport, e.g. stainless steel stand.• Before each startup, check that the probe is firmly positioned on the standard or booster horn; ifnecessary, tighten the probe (see chapter 4.3.1).• Do not touch any oscillating parts (e.g. standard or booster horns, micro tips or tapered tips,titanium plates, ultrasonic transducer) during operation! Damage to health is possible.• Do not touch the sonication vessels with the oscillating probe - probes and vessels could bedamaged.• The sonication of liquids generates noise. Suitable accessories, such as a sound proof box,will minimise such noise considerably. If operating without a sound proof box, wear hearingprotection.• Warning, risk of splashing!This is especially the case with small sample quantities and when immersing oscillating probes.• Do not use combustible solvents in open reaction vessels since the operating safety ofthe homogeniser could be compromised. Safe extraction of combustible vapours must beguaranteed. When using a sound proof box, the vapours cannot escape.• Before any mounting or dismounting (chapter 4.4) of probes or standard/booster horns aswell as accessories, turn off the device and disconnect the ultrasonic transducer from the HFgenerator.12 / 44 51436a GB/2017-101 electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com