BANDELIN Sonorex Technik RM 16 UH Instructions For Use Manual

BANDELIN Sonorex Technik RM 16 UH Instructions For Use Manual Manual pdf 13 page image

132 PreparationCarefully unpack the ultrasonic/rinsing bath and accessories and inspect them forcompleteness or possible transportation damages. If any damages or defects arefound, these must be immediately notified in writing to the transportation company andto the supplier.Before startup, the ultrasonic bath is to be left to stand at its operating location for2 hours so that it may adapt to the ambient conditions.2.1 Scope of delivery1 Ultrasonic/rising bath, see delivery note1 Accessories kit1 Instructions for Use manualAdditional accessories according to order - see delivery note2.2 Set-up / assembly• Place the ultrasonic/rinsing bath on a firm, level and dry surface. In doing so- observe the maximum weight of the tank, including liquids.For net weight, see technical data, chapters 1.4.1 to 1.4.3.- do not block the air supply below the tank.- guard against moisture and wetness - risk of electric shock.Set-up Fully remove transportation aids (pallets, transport safety devices). Set up the ultrasonic/rinsing bath in a dry room. Mount the separately-packaged ball valves for each tank as follows:1. Screw the counter nut onto the threaded sleeves 1 at thetank outlet (3-way ball valve) and tank overflow (ball valve),then seal with the white PTFE tape provided, applyingseveral turns of tape to the right.2. Tape the hose socket threads 2 with PTFE sealing tape.3. Screw the hose sockets 2 into the ball valve outlets 3, usethe appropriate spanner.4. Screw the ball valve 3 onto the threaded sleeves andtighten with the counter nut 4.Caution: Do not screw the ball valve up to the limit stopor back it off by rotating it slightly to the left, this will causethe PTFE tape to lose its sealing effect.5. Close ball valve, turn the lever 5 upwards.View from above:41 32 5openopen closed2screwed-in