BEC 7404 Series User Manual

Contents

Chapter 4: Configuration 126Special dial codesThe following table lists the special dial codes that are built-in to the system:Option DescriptionFlash-hook(Wireless Router with LINEport only)Switch to PSTN lineNote: A quick press of the hook. On some phones a button is providedwhich provides Flash-hook functionality. The button is marked "FLASH"or "RECALL".*69Return the last missed call for SIP service onlyNote: Entering this on a phone will call the last number which made acall to the phone. For example A makes a call to B, but hangs up beforeB answers. If B enters *69, A will be called.## Last number redial*20Set do not disturb onNote: It is possible to set a Do-Not-Disturb feature on a phone such thatany phone which calls the phone will receive an engaged tone and thephone called will not ring. For example, B enters *20 and hangs up. Amakes a call to B, and receives the engaged tone and phone B does notring.*80 Set do not disturb off*74#Set the number for Speed dial code ‘x’, where ‘x’ is anumber between 2 and 9.Note: Where is a number between 2 and 9, and is thenumber to dial. The code needed to dial a speeddial from a phoneconnected to a VoIP Router is:<x>#, where is a number between 2 and 9.The settings will infect to your setting in Speed Dial on WEB GUI.*90Set the number for performing Blind Call Transfer, where

is the number that you wish to transfer the

call to. It’s for SIP service only.Note: In Blind Call Transfer, you have a call in progress (incoming oroutgoing) and decide you wish to transfer the call to another phone. Totransfer the call, perform the following steps:1. Hook-flash to get a dial tone.2. Dial *90 (e.g. *907401), there will be a confirmationtone then hang up. The other end will hear ring back and the called third-party phone will ring. When the third-party phone is picked up the twocalls will be connected.If the third-party phone does not answer then the caller being transferredcan hang up to cancel the connect attempt.