Baby Jogger city GO Instruction Manual

Also see for city GO: Manual Manual Instructions Instructions

Contents

Baby Jogger city GO Instruction Manual Manual pdf 21 page image

21Before installing base, make sure vehicle is onlevel ground. Place base on an approved vehicleseat location.1 Ensure the vehicle seat belt is not twistedand route the vehicle belt through the first beltpath opening then under the belt lock-off anddown through the second belt guide.2 Buckle the vehicle seat belt.BASE INSTALLATION - LAP/SHOULDER BELT1233 While pressing the base down into the seat,pull on the vehicle belt to tighten.4 Close the lock-off over the lap belt until itclicks into place.Note: Check to make sure base is secure bymoving the it from front-to-back or side-to-side at the vehicle belt path. The vehicle beltshould not loosen and the base should notmove more than 1 inch from side to side or frontto back.4CLICK