THREADING15Left Needle C-11. Raise presser foot and place the thread on the far left spool pin. Slip the thread into the telescopicantenna thread guide directly above the thread spool. See drawings below for reference.2. Bring thread down from the telescopic antenna, snap thread into the orange thread guide on thetop of the machine, and then down into the orange hole above the tension dial.3. Bring the thread down the right side of the orange tension dial, under the dial and back up the leftside, making sure the thread is in the tension disk.4. Bring the thread through thread guide at top of machine and down to the pretension thread guideabove the needle.5. Pass the thread from the left side behind the pretension thread guide plate on needle clamp andinto thread guide above the needle. See drawings below for reference.6. With the needle threader or tweezers in the accessory compartment, thread needle in the left "C1"needle position.Center Needle C-21. Raise presser foot and place the thread on the second from the left spool pin. Slip the thread intothe telescopic antenna thread guide directly above the thread spool. See drawings below for reference.2. Bring thread down from the telescopic antenna, snap thread into the yellow thread guide on the topof the machine, and then down into the yellow hole above the tension dial.3. Bring the thread down the right side of the yellow tension dial, under the dial and the thread guidebelow the dial.4. Bring the thread through thread guide at top of machine and down to the pretension thread guideabove the needle.5. Pass the thread from the right side behind the pretension thread guide plate on needle clamp andinto thread guide above the needle. See drawings below for reference.6. With the needle threader or tweezers in the accessory compartment, thread needle in the center"C2" needle position.Right Needle C-31. Raise presser foot and place the thread on the back right spool pin. Slip the thread into the telescopic antenna thread guide directly above the thread spool. See drawings below for reference.2. Bring thread down from the telescopic antenna, snap thread into the green thread guide on the topof the machine, and then down into the green hole above the tension dial.3. Bring the thread down the right side of the green tension dial, under the green dial and under thethread guide located below the yellow tension dial.4. Bring the thread through thread guide at top of machine and down to the pretension thread guideabove the needle.5. Pass the thread from the right side behind the pretension thread guide plate on needle clamp andinto thread guide above the needle. See drawings below for reference.6. With the needle threader or tweezers in the accessory compartment, thread needle in the right "C3" needle position.NOTE:After threading the needles, the thread is then place to the left and top of the presser foot.Chain / Cover Needles