Baby Lock Spirit BLPY Instruction And Reference Manual

Also see for Spirit BLPY: Quick reference guide

Contents

PREPARING FOR BOBBIN WORKHow to Create Bobbin Work (Embroidery)Embroidering E-91E3■ When tension is not applied to thebobbin threadIf the bobbin thread in the trial stitching is too tightand adjusting the bobbin case tension does not help,do not pass the thread through the tension spring.Hold the bobbin with your left hand so the threadunwinds from the right side and hold the end of thethread with your right hand.n Pull out about 8 cm (approx. 3 inches) ofbobbin thread.o Lightly hold the end of the upper threadwhile turning the handwheel toward you(counterclockwise) until the mark on thehandwheel aligns with the center top ofmachine.p Gently pull the upper thread to bring thebobbin thread up through the needle plate.→ A loop of the bobbin thread comes out through thehole in the needle plate.q Insert tweezers through bobbin thread loopand pull bobbin thread above the needleplate.r Align the upper thread and bobbin thread,and then pull out about 10 cm (approx.4 inches) of the threads and pass themunder the embroidery foot toward the rearof the machine.s Install the bobbin cover with tabs.a Bobbin cover→ This completes the upper and lower threading.CAUTION• When creating bobbin work, use the bobbincover with tabs, otherwise the thread maybecome tangled or the needle may break.