Baby Lock evolve BLE8W Instruction And Reference Manual

Also see for evolve BLE8W: Service manual Service manual Service manual Instruction and reference guide

Contents

Baby Lock evolve BLE8W Instruction And Reference Manual Manual pdf 84 page image

Before taking your machine in for service, check the following:Machine fails to start:1. Are electrical plugs properly connected?2. Is the power switch on?3. Check household circuit breaker or fuse.4. Is the lock button release lever in the unlocked position?Thread breaks:1. Is the machine threaded correctly? Check each thread path carefully.2. Is the correct needle inserted for the particular stitch? - C-1, C-2, C-3, O-1, or O-2?3. Is the needle inserted correctly?4. Is the needle bent and worn?5. Are you using good quality thread?6. Is the thread feeding off the cone/spool freely?7. Is the needle size correct for the type of fabric being used?8. Are the needles being used the correct Schmetz or Organ ELx705CF system?Chain or Cover Stitching:1. Are the tensions too tight on the chain/cover needles or the chain looper?2. Is the stitch length too short?3. Did you start the first stitch in the fabric?Overlock stitching:1. Is the stitch selector on the proper setting?2. Is the upper looper positioning lever in the "UP" position?Skipped Stitches:1. Is the needle bent or worn?2. Is the needle inserted correctly?3. Is the serger threaded correctly?4. Is the presser foot pressure right for the fabric?5. Is the correct needle being used for the particular stitch?6. Is the correct needle being used for the type of being sewn fabric?7. Is the fabric being pulled from the rear of the machine while sewing?Fabric will not feed in machine:1. Is the machine lock button released?2. Is the presser foot down?3. Are the cutting blades sharp?4. Are the cutting blades, presser foot, and feed dogs free of lint?5. Are the cutting blades properly set and is the upper blade against the lower blade?6. Is the presser foot pressure right for the fabric?7. Is the stitch length set properly?8. Is the needle plate secure on the machine?MAINTENANCE82Troubleshooting