Bacchus BCS2000 Installation Manual
Also see for BCS2000: Installation manual
        | |
This will prevent any possible mold build up.4. Check the operation of the condensate pump, and make sure the watermisting fitting is acting properly, by allowing water to flow thru it.Clean with vinegar if clogged and change the water filter.5. Check the electronic controller for any alarm conditions6. Check the refrigerant level and system operating pressures.7. Clean the water solenoid on a yearly basis, and change it out every two years.Warning: If the water solenoid sticks open, overflow can result.TroubleshootingAlarm conditions on the electronic controller, Call BCS Tech Services at 937-665-0424Unit will not reach temperature Call your installation contractor to Determine proper refrigerantcharge. Dirty condenser?Unit has shut off Call BSC tech services or field Service; could be bad Compressor,fans, controller or PumpAlarm SignalingMessage Cause Outputs“P1” Thermostat probe failure compressor and heating outputs off(on dehumidification system only)“P3” Humidity probe failure humidity regulation off“HA” High temp alarm outputs unchanged“LA” Low temperature alarm outputs unchanged“HHA” High humidity alarm outputs unchanged“HLA” Low humidity alarm outputs unchangedIn the instance of any of these alarms, call Bacchus Tech Services, or your local service contractorDimensional /ElectricalBCS1000 BCS1000 BCS1500 BCS1500 BCS2000 BCS3000Cond. Unit Evap. Con. Unit Evaporator Con. Unit Con. UnitDims. 17”D x 13.3”W 18”D x 29.25”W 19”D x 16.2”W 18”D x 29.25”W 19”D x 21’W 25” D x 20”Wx 11.8”H x 6.5”H x 14”H x 6.5”H x 16.5”H x 16”HWeight 51 lbs. 49 lbs. 62 lbs. 51 lbs. 81 lbs. 135 lbs.Refrigerant 3/8” suc. 3/8”sw 3/8” suc 3/8” sw x 3/8” suc ½” sucConnection 1/4” dis. ¼” dis ½” sw 5/16” dis 3/8” disWater Supply ¼” ¼”Connection compression compressionCondensate ¼ mpt ¼” mptConnection7 |
manualsdatabase
Your AI-powered manual search engine